Page 1 of 1

Pump for water weirs

PostPosted: Tue Nov 06, 2012 12:06 pm
by lwparchive
Hi, I'm looking for an electric sump, or effluent, submersible water pump with capacity of 50 to 60 gpm at an operating pressure of about 40 psi.
We are pumping from a large sump that is 10-12' deep.
We are running a calibration of water weirs, with the lowest flow rate being
1 gpm and the maximum being 40 gpm, but the flow rates into the weir are controlled by two flow controllers in parallel. The flow controllers each need 20 psi at the inlet and each has a 10 psi drop through the device.

Re: Pump for water weirs

PostPosted: Thu Dec 20, 2012 3:11 pm
by dlamp67
it would be best if you contact our office so we can discuss your application.