Page 1 of 1

Pump stopped working

PostPosted: Tue Nov 06, 2012 12:13 pm
by lwparchive
the submersible well pump quit working 07-01-2011 the pressure switch points were burnt and pitted, a new pressure switch of the same spec's, and make, was installed following the old wiring positions. not working at this time.

c. long

Re: Pump stopped working

PostPosted: Fri Nov 30, 2012 4:28 pm
by dlamp67
You will need to check your control box, if used. You may have a problem with the pump motor or the submersible pump wire in the well. I would check these items first.