Page 1 of 1

Pump loses prime after repair

PostPosted: Fri Nov 09, 2012 3:01 pm
by lwparchive
I recently purchased from you an ejector for a Pulsafeeder chem tech pump.
Installed it as instructed and everything worked fine. Pump and ejector still work fine but pump loses its prime when it shuts off. Possible solutions? Thanks Bill Rutledge

Re: Pump loses prime after repair

PostPosted: Tue Apr 02, 2013 12:59 pm
by dcohan
COULD BE THE VALVE SEATS AT THE TOP AND BOTTOM OF THE PUMP. THERE IS ALSO A SEAT IN THE FOOT VALVE. IF THESE ARE BAD PUMP WILL LOSE PRIME