SLE-L - Sta-Rite Deep Well Jet Pump

1 HP - 115/230 Volt - Deep Well Jet

The ProJet SL convertible jet pumps offer a proven cast iron self-priming design available in 1/2 to 1-1/2 HP models. The ProJet SL convertible jets utilize the built-in regulators, offering easier priming and better range of performance from a complete line of shallow well, 4 Inch double pipe, 2 Inch and 3 Inch single pipe jet packages.

APPLICATIONS

• Water systems and sprinkling for homes, farms and cottages.

FEATURES

Quality construction:
Close-grained cast iron pump body is rugged one-piece unit, specially treated to resist corrosion. Drain port provided for easy winterizing.

Noryl impeller:
Precision-molded for perfect balance...ultra-smooth for highest performance and efficiency.

Precision-Molded Diffuser:
Pump primes faster, handles more air, with multi-port, precision-molded, reinforced polypropylene diffuser.

Pressure Switch:
High-quality, cut-in pressure setting is adjustable. Fixed 20 PSI differential.

Mechanical Shaft Seal:
Precision-lapped and highly polished carbon-ceramic, stainless steel construction. Internal design guarantees continuous water lubrication for maximum protection.

Motor Windings:
Superior insulation materials protect against excessive moisture and contaminants assures prolonged motor life.

Balanced Rotor:
Diecast under high pressures for uniform performance and greater efficiency dynamically balanced.

Heavy-Duty Ball Bearings:
Shielded, permanently lubricated bearings, extensively tested to ensure extended life and smooth, quiet operation.

Pump and Motor Shaft:
416 stainless steel for maximum corrosion resistance; one-piece threaded shaft for positive impeller drive and alignment.

Dustproof cover:
Dustproof canopy protects all electrical components from dirt, dust and insects; ventilating air cannot contaminate vital switching components eliminates the most common cause of motor failure.

SPECIFICATIONS

Body and Seal Plate: Close-grained cast iron

Impeller: High-strength

Noryl Diffuser: Reinforced polypropylene with brass wear ring

Shaft: One-piece threaded 416 stainless steel

Base: Steel, 12 gauge

Max. Liquid Temperature: 140 F Max. inlet Pressure: 50 PSI Pressure Switch Pre-Set: 30–50 PSI

Suction Ports: Suction-over-Drive