3AB2 - Goulds Pumps Aquavar ABII Controller

10.0 Amps - 3HP - 230V - Variable Speed Constant Pressure Pump Control

The Aquavar ABII pump controller provides an economical answer for municipal and private water systems with low water pressure. Both domestic and light commercial above ground boosters can benefit. As water use increases, the controller changes pump speed to maintain pressure. Large supply tanks are eliminated and up to 50% of the energy required by a full speed pump is saved.

APPLICATIONS

Residential and Commercial Applications

FEATURES

• Input Power: 196-264 Volts, single phase 2-wire, grounded
• Output Power: Up to 230V three phase (based on input voltage). Motor rated for 208- 230 V.
• Input Controls: Press and hold pressure in- crease/decrease buttons. Minimum speed and motor overload switch.
• Signal Light: Power on, pump running, pump stopped, faults/errors.
• Electrical Efficiency: Over 95%
• Protection Against: Short circuit, over/un- der voltage, motor overload, dead heading, suction loss, sensor fault, bound pump, over/ under temperature.
• Ambient Temperature: 14° F to 122° F
• Maximum Humidity: 95% at 122° F, non-condensing
• Enclosure: NEMA 3R, IP 22 (Rain-tight)
• Mounting: Mount vertically, screws included
• Cooling: Convection with heat sink and fan
• Transducer: 0.5 - 4.5 VDC with 5 VDC power supply, 10' 3-wire cable.

SPECIFICATIONS

• Amperage / HP Range: 10.0A / 3 HP maximum
• Unit Weight: 21 lbs.
• Packaged Weight: 23 lbs.
• Pressure Set Point: adjustable from 20 - 85 PSI with 100 PSI transducer
• Includes: 100 PSI Transducer, 10' Transducer Cable, Mounting Screws and Ground Clamp

Controller Temperature Range:

• Minimum Ambient Temperature: 14° F (-10° C)
• Maximum Ambient Temperature: 122° F (50° C)

Input Voltage: 196 - 264 Volts, 1 Phase, 2-Wire Grounded

Output Voltage: Up to 230V, 3 Phase based on input voltage

Enclosure Dimensions:

• Height: 18.6
• Width: 9.9
• Depth: 5.3

Packaged Dimensions:

• Height: 21
• Width: 13
• Depth: 8